Post time: 30-03-23Iron products are common metal products in life. Iron products appear everywhere in our life, but there is a big problem in using iron products. Iron products will rust, and when rust occurs, it will affect the use and appearance of iron products. Adding non-metallic coating: clean, dry and coat the surface of iron and steel products with a layer of protective materials, such as oil, mineral grease, rust-proof grease, plastic and lacquer.
The lighting surface of each type of shed is designed to be curved, improving the Angle of the light surface, because the lighting surface is curved, no dust accumulation, good light transmittance, high temperature in the shed, after measurement, the average temperature in the shed is 3℃ higher than the traditional bamboo pole cement column shed, the yield is increased by 15~20%, and the harvest date is advanced. The formula is scientific, the surface does not absorb moisture, do not return halogen through modification technology and scientific production process, solve the greenhouse frame rod is easy to absorb moisture return halogen, poor water resistance and easy to change the shortcomings, so that the greenhouse steel pipe in the high temperature and high humidity environment, few drops, frost phenomenon, and reduce pests and diseases.
The entire steel surface is protected, and the melted zinc is easily coated evenly, whether in the interior of the pipe fitting in a depression, or in any other corner where the coating is difficult to access. The hardness of galvanized coating is greater than that of steel. The Eta layer of the upper layer of Z is only 70 DPN hardness, so it is easy to be dented by collisions. However, the hardness values of the lower layer of Zeta layer and delta layer are 179 and 211 DPN respectively, which are higher than that of the iron material of 159 DPN. Therefore, its impact resistance and wear resistance are quite good.
Post time: 24-05-23The welding process of galvanized steel wire mesh because of low carbon steel carbon content is low, manganese and silicon content is low, will not occur severe hardening or quenching structure due to welding. The low carbon steel joints have excellent plasticity and impact toughness after welding. In the welding process, it is generally not necessary to preheat, interlayer temperature control, post-heating control and heat treatment to improve the welding structure.
Post time: 21-02-23- In addition, galvanized silk manufacturers can be required to passivation treatment after zinc immersion, after passivation treatment of zinc has a better anti-discoloration effect, can effectively extend the time of discoloration, the combination of the two, discoloration should be able to solve.
- 1, first of all, the net surface is smooth, mesh are four lines, pitch is the same, whether the weft wire bending (note: the net width is the length of the weft wire), normal weft wire passes through the straight wire of welded wire mesh, with accurate time and the silk repeated welding, make the pitch of welded wire mesh is consistent, with smooth surface, into a square hole, when the net vertical position from the top downwards see, weft wire is straight.
- 2. Choose the dog cage according to the material
There are a variety of arc, non-divergence Angle and non-divergence height ladder types installed to provide ideal treatment plans. It can be used together with the appearance and the common design of the trackless active shift door, forming a harmonious and intact whole.
Post time: 04-11-22
Post time: 07-06-24PVC coated barbed rope is widely used for railway highway protection, but also for safety protection of rivers, embankments and seawalls, so as to better protect the safety of people and animals.
After the optimization of the process, mass production of 0.80mm electro galvanized steel wire electro galvanized zinc layer quality is controlled within 80 ~ 90g/m2, zinc layer quality dispersion is very small; The results show that the average weight of zinc layer is 14.5g/m2, the loss of zinc layer is less than 5%, and the tensile strength of steel wire is 2300 ~ 2500MPa. It not only effectively controls the quality of zinc layer of raw steel wire, but also reduces unnecessary waste and production cost.
- 1, first of all, the net surface is smooth, mesh are four lines, pitch is the same, whether the weft wire bending (note: the net width is the length of the weft wire), normal weft wire passes through the straight wire of welded wire mesh, with accurate time and the silk repeated welding, make the pitch of welded wire mesh is consistent, with smooth surface, into a square hole, when the net vertical position from the top downwards see, weft wire is straight.
- Nemator roller cage is connected by nemator connecting clasp with longitudinal tension bar fixed on the support, and the connection between longitudinal tension bar and support is selected. The 2.5mm cold-drawn galvanized steel wire is wound 2 times and then tightened and fixed. The bracket is set on the column and the cross side of the protective fence with a span of 3m. Other spans are only set on the upper part of the column, and the bracket and the protective fence are connected with the bracket hoop.
- The principle of hot dip galvanizing is simply that clean iron parts are immersed in a zinc bath through Flux wetting, so that the steel reacts with molten zinc to produce an alloyed skin film.
Galvanized wire is divided into hot dip galvanized iron wire and galvanized iron wire according to the production process. It has the characteristics of high tensile strength, good softness, zinc layer uniformity, corrosion resistance, beautiful color, good smoothness, strong adhesion and corrosion resistance. Hot dip galvanizing has better protective properties than electric galvanizing, so it is an important protective coating for steel parts used in harsh working conditions.
Post time: 28-06-22
Post time: 15-02-23Cold galvanizing, also called electric galvanizing, is the use of electrolytic equipment to remove oil, pickling, after the pipe fitting into the composition of zinc salt solution, and connected to the negative electrode of the electrolytic equipment. Wire factory on the opposite side of the pipe fittings placed zinc plate, connected to the positive electrode of the electrolytic equipment is connected to the power supply, the use of current from the positive electrode to the negative electrode will deposit a layer of zinc on the pipe fittings, cold plating pipe fittings is first processed after galvanized.
- Before wall plastering, the wall column is connected to the gap construction wire mesh, which can play a certain strengthening and heat preservation effect. The mesh is hung on the interface surface of different grassroots, and the length of each side should meet the requirements of 100mm, so as to prevent shrinkage and cracking caused by different grassroots. Mesh wire diameter can also determine the effect and efficiency of construction, mesh fine laid up convenient soft, high construction efficiency; Of national standard can assure quality, but laid respect is inferior to fine construction fast.
- Both sides of the galvanized welding net exposed can not be more than 2mm, so as to be qualified. And in the welding mesh of each warp and weft wire cross place, must be welded very firm, and if you want to welding very firm, both sides must have some warp and weft wire out, and the length must be controlled within two millimeters. From the mesh distribution is not uniform, galvanized is not uniform, but also to see whether the welding mesh is qualified standards.
Barbed rope used to enclose cattle, sheep and other livestock is also the biggest characteristic of low price, for users engaged in breeding industry, the investment is not small, the use of barbed rope fence on the one hand is to reduce the cost, on the other hand, is better protection effect.
- Good word of mouth blade barbed rope must be a reasonable evaluation given by consumers after using, this is because many people feel good after choosing the blade barbed rope, whether in terms of safety protection or in the overall decoration and beautification effect is very good, so that in the actual choice will be more assured, In the eyes of many people, the high quality razor cord will not have problems, or the overall service life is really long, so that we can reduce a lot of cost, and can know whether it is the best.
Post time: 03-11-22- Nemator roller cage is connected by nemator connecting clasp with longitudinal tension bar fixed on the support, and the connection between longitudinal tension bar and support is selected. The 2.5mm cold-drawn galvanized steel wire is wound 2 times and then tightened and fixed. The bracket is set on the column and the cross side of the protective fence with a span of 3m. Other spans are only set on the upper part of the column, and the bracket and the protective fence are connected with the bracket hoop.
The hot plating wire is made of low carbon steel wire rod, which is processed by drawing forming, pickling and rust removal, high temperature annealing, hot dip galvanizing and cooling. Galvanized iron wire has resistance and elasticity, the amount of zinc can reach 300 g/square meter, with thick galvanized layer, strong corrosion resistance and other characteristics. Widely used in construction, handicrafts, wire mesh, highway guardrail, commodity packaging and ordinary civilian and other fields.