Lithopone is an inorganic white pigment, obtained from co-precipitation of Zinc sulfide (ZnS) and Barium sulfate (BaSO4). As a white pigment, it acts as a cost-effective alternative for TiO2. Some of the properties of Lithopone include high brightness and performance under UV exposure. Lithopone requires less wetting agent to achieve optimum wetting of its surface. It is commercially graded on the basis of amount of ZnS. Its grades include 28%, 30%, and 60% ZnS. As a comparatively inexpensive white pigment, Lithopone is presently used in various paint formulations, road marking paints, jointing compounds, and putties.

Titanium dioxide is an inert earth mineral used as a thickening, opacifying, and sunscreen ingredient in cosmetics. It protects skin from UVA and UVB radiation and is considered non-risky in terms of of skin sensitivity. Because it is gentle, titanium dioxide is a great sunscreen active for sensitive, redness-prone skin. It’s great for use around the eyes, as it is highly unlikely to cause stinging.

Faber argued there hasn't been enough change in these federal regulations in the decades following the FDA's approval of titanium dioxide – especially as others increasingly point to potential health consequences.

The basic scenario of resistive switching in TiO₂ (Jameson et al., 2007) assumes the formation and electromigration of oxygen vacancies between the electrodes (Baiatu et al., 1990), so that the distribution of concomitant n-type conductivity (Janotti et al., 2010) across the volume can eventually be controlled by an external electric bias, as schematically shown in Figure 1B. Direct observations with transmission electron microscopy (TEM) revealed more complex electroforming processes in TiO₂ thin films. In one of the studies, a continuous Pt filament between the electrodes was observed in a planar Pt/TiO₂/Pt memristor (Jang et al., 2016). As illustrated in Figure 1C, the corresponding switching mechanism was suggested as the formation of a conductive nanofilament with a high concentration of ionized oxygen vacancies and correspondingly reduced Ti³⁺ ions. These ions induce detachment and migration of Pt atoms from the electrode via strong metal–support interactions (Tauster, 1987). Another TEM investigation of a conductive TiO₂ nanofilament revealed it to be a Magnéli phase Ti_nO_2n−1 (Kwon et al., 2010). Supposedly, its formation results from an increase in the concentrations of oxygen vacancies within a local nanoregion above their thermodynamically stable limit. This scenario is schematically shown in Figure 1D. Other hypothesized point defect mechanisms involve a contribution of cation and anion interstitials, although their behavior has been studied more in tantalum oxide (Wedig et al., 2015; Kumar et al., 2016). The plausible origins and mechanisms of memristive switching have been comprehensively reviewed in topical publications devoted to metal oxide memristors (Yang et al., 2008; Waser et al., 2009; Ielmini, 2016) as well as TiO₂ (Jeong et al., 2011; Szot et al., 2011; Acharyya et al., 2014). The resistive switching mechanisms in memristive materials are regularly revisited and updated in the themed review publications (Sun et al., 2019; Wang et al., 2020).