3、About production

Storage and Handling

Oil Gasket Seal:

The seal shown in Fig. 14.2 is a relatively simple design; most automotive seals are more complex. Dust lips are often used to keep outside contaminants away from the oil lip seals; such seals thus have undercuts that make demolding more difficult. Fluoroelastomer compounds used for such undercut shapes must have reasonably high elongation at break at molding temperatures to avoid tearing the part during demolding. The metal insert is often U-shaped, and stock may be molded to form a thin layer over the outside of the insert. Since both compression and injection molding methods are used, suppliers of fluoroelastomers for shaft-seal applications often must provide different versions of the same polymer composition-medium to high viscosity for compression molding, and low to medium viscosity for injection molding. Different precompounds may be necessary to accommodate relatively long compression-molding times at low temperature and very short injection-molding times at high temperature.

If the gap is larger than 0.002 in. (0.05 mm) at any point, have the head or block checked and machined flat by a specialist.

Always start by making sure the oil seal is facing the right direction. The oil seal must be positioned with its spring to the side of the medium to be sealed. The oil seal must then be pressed into the bore. It must fit tightly (H8 in the groove is recommended). Use appropriate tools for this, such as an impact socket set, to ensure that the force is applied evenly during pressing. The oil seal must never be hammered into the bore with brute force, but eased in.