4. Keep the rinse water clean after pickling the steel wire
- Annealing is to restore the plasticity of wire, improve the tensile strength of wire, hardness, elastic limit, etc., the wire after annealing is called annealing wire. In the production process of annealing wire, it is very important to ensure the quality of the finished wire, make the wire have certain strength and suitable degree of soft and hard. The annealing temperature is between 800 ℃ and 850℃, and the length of furnace tube is lengthened appropriately for enough holding time.
Plastic paint is often see way of electrostatic daub, can be fixed on the periphery of the barbed wire or iron wire board, requires two baidu after heat treatment, make plastic paint or powder coating adhesive on the wire plate, these are painted plastic razor wire is commonly used in indoor boxes, plastic paint surface look overall feeling is very good, strong adhesive force, at the same time is more durable, Coating processing does not take too long, mainly rust prevention and corrosion effect is quite good, much better than the general material.
The application range of positive and negative twisted barbed wire is also very wide. It is a good choice for purchasing barbed wire. So what are the advantages of positive and negative twisted barbed wire compared with other barbed wires? The following barbed wire factory will introduce the positive and negative twisted wire in detail. Three advantages of rope
- Annealed wire is a kind of soft iron wire made of low carbon steel by cold drawing, heating, constant temperature and heat preservation. The composition of the wire varies according to its use. It contains iron, cobalt, nickel, copper, carbon, zinc, and other elements. The hot metal billet is rolled into 6.5mm thick steel bar, that is, the wire rod, and then it is put into the wire drawing device to draw the wire of different diameter, and gradually reduce the aperture of the drawing disk, cooling, annealing, plating and other processing technology to make a variety of different specifications of the wire.
The application of electric welding mesh is more and more widely, the technology is gradually mature, electroplating rust prevention, plastic coated treatment, used for breeding, grille, plus the frame to make a fence, etc.
Spray powder mainly acrylic powder, polyester powder and so on. Dipping is a kind of plastic coating process, that is, the plastic coating on the matrix, generally metal, such as: daily use of clothes hangers, pliers handles, scissors on the rubber sleeve, various handrails, etc. Plastic immersion is to heat the metal to spray plastic powder evenly on the metal to form a plastic film, or heat immersion liquid into the metal to cool it and then plastic coating on the metal surface.
Now most people want to choose a few when choosing barbed wire material better thorn rope, but the special barbed wire the better, not right, it is important to choose which model is most suited to their own thorn rope,, although is very simple product, but in the use of these products are for specific situation is different, and has a different effect, Maybe now consumers do not have too much concept of blade barbed rope, in fact, such barbed rope products have a higher safety factor.
Wire mesh even in the mining industry also has a higher reflection, because the selection of low-carbon materials to do the material so that it has a general iron net class does not have flexibility, concluded that its plasticity in use, and then can be used in hardware crafts deep processing production, as the wall plastering, leak prevention crack and so on. Its light net body, lower cost, more can let customers experience its economic benefits.
Post time: 26-04-23There is a connection between the hook mesh and the aperture, in short, the general hole small hook mesh, the wire is also very small; Aperture is large, hook mesh wire is generally larger. The weaving of the hook mesh also has certain rules, using the first pre-bent into a wavy wire, and then woven into the hook mesh. According to the knitting method, the hook mesh can be divided into: closed weaving, two-way plain weaving, one-way corrugated weaving, two-way plane weaving, two-way corrugated weaving, rectangular hole weaving.
Hot dip galvanized welding mesh is made of iron wire, processed by precision automatic mechanical technology. The mesh surface is smooth, the structure is strong, and the integrity is strong. Even if the local cutting or local pressure is not relaxed, the hot dip zinc is processed. Hot dip galvanized welding mesh surface white color, thick zinc layer, high zinc content at the solder joint, uniform mesh, flat mesh surface, solder joint tensile resistance, high corrosion resistance. It has the advantages that ordinary barbed wire does not have.
- A. When the thickness of the plating is 3-4 mm, the zinc adhesion should be less than 460g/m, that is, the average thickness of the zinc layer is not less than 65 microns.
Through the maintenance of galvanized wire, it can not only greatly prolong its service life, but also improve its efficiency in the daily use process. Because the labeled electrode potential of zinc is -0.762v, which is negative than iron, zinc becomes the anode when the galvanic cell is formed after being corroded by the medium. It itself is dissolved to protect the steel matrix. The duration of the protection of galvanized wire layer has a great relationship with the thickness.
- 2. The positive and negative twisting barbed wire is cost-effective
High quality galvanized wire in general, the zinc layer attached to the surface of the wire is relatively thick, so when we buy galvanized wire, as long as we look at the thickness of the zinc layer machine, we can generally judge whether the quality of galvanized wire is high quality.
With other coatings, the opposite is true. Rust builds up immediately and spreads quickly underneath the coating, causing it to peel. The depletion of zinc in the atmosphere is very slow, about 1/17 to 1/18 of the corrosion rate of steel, and is predictable. Its life span far exceeds that of any other coating. The life of the coating depends on the thickness of the coating in a particular environment. And the coating thickness is determined by the thickness of the steel, that is, the thicker the steel is easy to get thicker coating, so the thick steel part of the same steel structure must also get thicker coating, in order to ensure a longer life.
The advantages of the blade stabbing rope (1) lightweight, high strength, never rust, good softness, fatigue resistance, impact resistance, breaking force, the overall structure is strong and durable, the service life is more than 30 years; (2) Close to nature, green environmental protection, highly effective protection of bird feathers and animal skin, effectively prevent rodents and other animals from biting, to give animals a safe and comfortable living environment; (3) Good visibility through l, luxurious appearance, novel style, itself is a big landscape. We can send you samples and make sure they are consistent. Our TECHNICIANS and ENGINEERS can also visit our factory free of charge for site investigation and design. According to your requirements and specific application environment, we can provide detailed material, rope diameter, hole distance and overall structure advice to guide installation.
- Electric welding mesh can be made into the form of mesh, mesh surface can be used to dip plastic or spray plastic process, forming a layer of protective film on the surface of electric welding mesh, can effectively make the wire and the outside of the water or with corrosive substances isolation, can achieve the effect of increasing the use of time, can also make the mesh surface show different colors, so that the mesh to achieve beautiful effect. Impregnated mesh is usually used for outdoor, and column link, can play a protective anti-theft effect.
- Second, positive and negative twisting rope cost-effective
- The wire mesh is finished by fine welding of active welding equipment. The material can be divided into cold drawing wire, hot dip galvanized, cold galvanized, dip plastic and so on. To be used for bridge reinforcement, deck paving, building reinforcement, etc.
- And for the external insulation system is used in the brick veneer, as for the role of first should also be anti fall off followed by anti cracking, so should choose the grid 10×10×0.6, these are some experience choice, grid conversion from the national regulations of steel mesh specifications, using steel level conversion. The index of wire mesh size, wire warp, square meter steel content, galvanized amount, etc., mainly consider the corrosion resistance of wire mesh and the safety of the system! Galvanized wire mesh is more critical than wire diameter, galvanized amount is very important, must be hot plating, welding after plating is better than plating after welding, as for wire diameter, comprehensive consideration of site construction and to meet the needs of safety, 0.6 ~ 0.7 is better.
- Galvanized iron wire has tolerance and elasticity, the amount of zinc can reach 300 g/square meter. It has the characteristics of thick galvanized layer and strong corrosion resistance. Widely used in construction, handicrafts, wire mesh, highway guardrail, commodity packaging and ordinary civilian and other fields.
Many pet cages are designed with a small box in the base, so that pets can clean up when they poop, but also convenient for pets’ health. For example, if there is no excreta box, pet excreta will be on the ground, which is quite unhealthy. If you have a box, it’s easy to take the box out and wash the trash away so it doesn’t get all over the place, so it’s more hygienic.
- 2.25*2.25mm means that the two strands are 2.25mm silk, and the barbed wire is also 2.25mm silk;
- 3, some stainless steel pet cage on the market does not use 304 or higher material, the so-called 202, 201 stainless steel is easy to rust, please users in the purchase of stainless steel pet cage as far as possible not to choose.
- 4, the material requirements of the silk: change wire braid, electric galvanized wire braid, hot galvanized wire braid, first braid after hot plating.
- The color of powder coating is divided into: razor wire blue, grass green, dark green, yellow. Plastic-sprayed blade gill net is made of hot-dip galvanized steel plate or stainless steel sheet stamped out of sharp knife sheet, high tension galvanized steel wire or stainless steel wire as core wire combination of resistance devices. Because the shape of the barbed rope is not easy to contact, so it can reach an excellent protective barrier effect. The primary raw materials of products are galvanized sheet, stainless steel plate, high quality low carbon steel wire (electric galvanized, hot galvanized, plastic coated, plastic spraying) wire, blue, green, yellow and other colors.
First, spray to prolong the service life of stainless steel barbed rope
- Cages are more often used for large dogs, which are very powerful. So choose a dog cage must be strong, otherwise the dog can easily break the cage and escape.
The national standard on the use of wire mesh standards have certain requirements, diameter and mesh size matching use, rather than simply diameter size, on the plaster layer to use is mesh should not be greater than 20×20, diameter is not easy to be less than 1mm, light selection diameter is not much significance, choose 40×40×0.9 and choose 10×10×0.6 wire mesh, Which is better, I’m afraid is 10×10×0.6.
After the corrosion of impregnated hexagonal wire mesh, the original characteristics will be lost, and the shape, color and mechanical properties will be changed, resulting in equipment damage, pipeline leakage, etc., specifically, it is easy to break and lose the original protection function. Usually, there are three kinds of metal corrosion: physical corrosion, chemical corrosion, electrochemical corrosion, corrosion in addition to the chemical properties and organizational structure of the metal itself, but also related to the surrounding medium, such as wet environment is easier to rust than dry environment, more impurities than impurities less easy corrosion, high temperature conditions than low temperature conditions easy corrosion. After understanding these, we can effectively prevent the corrosion of impregnated six-sided wire mesh, prolong the service life of the product.
When using these two products, it is obvious that there is a gap between them. By pulling or bending the wire, it is often difficult to restore the original, for example, if the same place is repeatedly bent, it will be found that it has broken, and the cold drawing wire will not. Cold drawing wire compared with iron wire, its hardness, tensile resistance, bending ability is greatly enhanced, suitable for building materials.
(1) The application method of packaging and binding galvanized shaft wire ordering: ① the pulling position on the goods should be reasonably selected. When used to avoid horizontal movement of goods, the pulling position should be as low as possible; When used to avoid overturning the goods, the pulling position can be appropriately high. ② The use of galvanized iron wire [1] pull reinforcement methods mainly include: figure eight, inverted figure eight, cross, zigzag or reverse zigzag and so on. Various pull methods can be used alone, but also two or more than two kinds of use. The pull should be as symmetrical as possible. (3) When pulling reinforcement, the single or double strands of galvanized iron wire will reciprocate around the goods and vehicles between the two tying nodes, and should be pulled tight galvanized iron wire so that the tightness of each strand is as common as possible, and some of the remaining cross around its own rope rod, and the rest of the tail toward the car.