Vulcanizates of several fluoroelastomers, listed in Table 14.1, were exposed to a standard 5W-30 engine oil, ASTM Service Fluid 105, for up to 6 weeks at 150°C (302°F).⁵ The oil was changed weekly, but was not aerated. Retained elongation was measured after exposure for 1, 2, 3, and 6 weeks; data are shown in Fig. 14.3. The results indicate that bisphenol-cured FKM-A500 VDF/HFP copolymer, FKM-B600 VDF/HFP/TFE terpolymer, and peroxide-cured FEPM-7456 TFE/P/VDF terpolymer lost most of their original elongation over the course of the test exposure, indicating considerable additional cross-linking occurred by reaction with amine- and phenol-containing oil additives. The other fluoroelastomers showed better retention of elongation, being much less susceptible to additional crosslinking. Note that FEPM-7456 contains a high level of VDF (about 30%), while FEPM-7506 contains a relatively low VDF level (10–15%) to serve as cure site for bisphenol curing. The other FEPM types contain no VDF.

There are many different materials used to manufacture oil seals.

Shaft surface speed

Type code

Put the jack and wooden spacer under the sump and raise the engine just enough to free the supports.

Are you looking to keep your machinery free from any unwanted leakages but aren’t sure which rotary shaft seal is right for your needs? This guide will provide you with everything you need to know in order to select the right one for your application.

PTFE, which is used in the well-known brand Teflon®, is less commonly used, but it is the preferred material for specific rotating seals in the chemical, food and pharmaceutical industries. This material is notable for having a very low frictional resistance and the best chemical resistance. It can also withstand a very wide range of temperatures in these types of seals; -80 ˚C to 200 ˚C. The shafts on which oil seals with PTFE lips are used require a harder and finer finish. Something like an axle sleeve can also be used to meet this requirement.