In food, titanium dioxide is often used as an artificial color additive. Tasha Stoiber, senior scientist at the consumer health nonprofit Environmental Working Group, says titanium dioxide can generally be thought of as a paint primer – it often goes on a hard-shelled candy like Skittles before the color is added to give it a uniform shine.

At the present JECFA meeting, the committee considered additional toxicological studies relevant to the safety assessment of the chemical that investigated its toxicokinetics, acute toxicity, short-term toxicity, long-term toxicity and carcinogenicity, genotoxicity, and reproductive and developmental toxicity, as well as special studies addressing its short-term initiation/promotion potential for colon cancer. The experts acknowledged that a large number of toxicological studies have been conducted using test materials, including nanoparticles, having size distributions and physico-chemical properties not comparable to real-world uses of titanium dioxide as a food additive. The studies on non-representative materials were evaluated by JECFA, but the committee concluded that such studies are not relevant to the safety assessment of the additive.

Lithopone is an inorganic white pigment, obtained from co-precipitation of Zinc sulfide (ZnS) and Barium sulfate (BaSO4). Titanium Dioxide (TiO2) has replaced Lithopone as a white pigment in majority applications as TiO2 is more durable. However, it is much cheaper than TiO2 and has advantages such as low binder requirement and good dispensability. As a white pigment, it can improve the substrate's weather resistance, and improve the fungicidal properties of paint formulations. Some of the major applications of Lithopone include manufacturing of paint pigments, plastic & rubber products, paper, printing inks, cosmetics, and leather & linoleum products. It is commercially available under names such as pigment white 5, Barium zinc sulfate sulfide, Becton White, C.I. 77115, Charlton White, Enamel White, and Zincolith. On the basis of content of ZnS, Lithopone is available at 28%-30% Lithopone and 60% Lithopone.

The basic scenario of resistive switching in TiO₂ (Jameson et al., 2007) assumes the formation and electromigration of oxygen vacancies between the electrodes (Baiatu et al., 1990), so that the distribution of concomitant n-type conductivity (Janotti et al., 2010) across the volume can eventually be controlled by an external electric bias, as schematically shown in Figure 1B. Direct observations with transmission electron microscopy (TEM) revealed more complex electroforming processes in TiO₂ thin films. In one of the studies, a continuous Pt filament between the electrodes was observed in a planar Pt/TiO₂/Pt memristor (Jang et al., 2016). As illustrated in Figure 1C, the corresponding switching mechanism was suggested as the formation of a conductive nanofilament with a high concentration of ionized oxygen vacancies and correspondingly reduced Ti³⁺ ions. These ions induce detachment and migration of Pt atoms from the electrode via strong metal–support interactions (Tauster, 1987). Another TEM investigation of a conductive TiO₂ nanofilament revealed it to be a Magnéli phase Ti_nO_2n−1 (Kwon et al., 2010). Supposedly, its formation results from an increase in the concentrations of oxygen vacancies within a local nanoregion above their thermodynamically stable limit. This scenario is schematically shown in Figure 1D. Other hypothesized point defect mechanisms involve a contribution of cation and anion interstitials, although their behavior has been studied more in tantalum oxide (Wedig et al., 2015; Kumar et al., 2016). The plausible origins and mechanisms of memristive switching have been comprehensively reviewed in topical publications devoted to metal oxide memristors (Yang et al., 2008; Waser et al., 2009; Ielmini, 2016) as well as TiO₂ (Jeong et al., 2011; Szot et al., 2011; Acharyya et al., 2014). The resistive switching mechanisms in memristive materials are regularly revisited and updated in the themed review publications (Sun et al., 2019; Wang et al., 2020).