titanium dioxide used in medicine

One common method to determine sulfate as TiO2 involves gravimetric analysis. In this technique, a sample containing sulfate is treated with barium chloride, resulting in the precipitation of barium sulfate. The precipitate is then filtered, dried, and weighed. The weight of the barium sulfate precipitate correlates directly with the amount of sulfate originally present in the sample. To express this as TiO2, a conversion factor based on stoichiometry is applied. This method, while straightforward, can be time-consuming and subject to errors in filtration and drying.

...

 2) Purification: Add ammonium persulfate to the final immersion solution for one-time oxidation and iron removal, and add activated carbon to adsorb arsenic and iron co-precipitation to achieve the purpose of removing arsenic. Add the polyacrylamide coagulant to separate and filter before separation. The sulfide solution is added to the solution to remove sulfur, and the separated filtrate obtained by the separation is replaced with zinc powder to remove the remaining impurities to obtain a zinc sulfate ammonia complex liquid, which is used in the next step;

...

Hemolysis was studied on suspensions of P25TiO2NPs (0.2 mg/mL and 0.02 mg/mL), vitaminB2@P25TiO2NPs (0.2 mg/mL and 0.02 mg/mL) and vitamin B2 (0.2 mg/mL and 0.02 mg/mL) were prepared and mixed with 500 μL of anticoagulated blood (donated by Laboratorio de Hemoderivados, UNC) in a rate of 1/10. A solution of NaCl 10% was used as the positive control and PBS as the negative control. Then, the samples were irradiated using the LED described above for 3 and 6 h to simulate the light penetration into the skin. Also, a set of samples was kept in the dark as control. Finally, the samples were centrifuged and the absorbance at 540 nm was measured in the supernatants. The experiment was reproduced twice; the standard deviation was calculated and p-value < 0.05 were considered significant.

...
...