Hot dip galvanizing, also known as hot dip zinc, is the method of forming a layer of zinc coating on the surface of the workpiece after oil removal and rust removal, showing a clean and infiltrating surface, immediately immersed in the plating tank of zinc melting in advance. Cold galvanizing is the same after the removal of oil, in addition to lure, showing no pollution, infiltration of the workpiece hung into a special electroplating tank on the cathode, the anode with zinc. Switch on the DC power supply, zinc ions on the anode migrate to the cathode, and discharge on the cathode, so that the workpiece is coated with a layer of zinc layer hot dip galvanizing method.
Post time: 13-09-22Abandoned barbed wire guardrail network will generally choose classification pick up, classification gathering pick up and other methods, better to promote the better use of the whole highway guardrail network, abandoned metal guardrail network is still common copper mesh profile.
- Wire diameter: 6#–20#, this wire mesh is made of low carbon steel wire braided; Aperture: 15′-15′ extra standard can be customized according to customer demand processing. Use: to be used for road beautification belt protection net, maintenance and support seawall, hillside, dam, etc., is to avoid landslides of the best information.
The external environment has a great influence on the storage of cold drawn wire. Especially during the rainy season, special attention should be paid to the air humidity of workshops and warehouses. It is recommended to use moisture test paper with a value between 8 and 10. If the PH value is high, attention should be paid to the corrosion of the internal cold drawing wire. Cold drawing wire in normal environment storage for two years no problem, cold drawing wire will not be corroded. However, it is necessary to place the coil gently during the handling process to avoid the winding position leading to the cable is not smooth.
- During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.
Post time: 24-11-22- The main raw materials of blade barbed wire are galvanized wire and galvanized sheet. Because the price of galvanized sheet is more expensive than galvanized wire, it is directly reflected in the price of blade barbed wire sales. There is also the difference in processing technology also leads to the difference in the price of the blade barbed rope. The traditional barbed rope is mechanically twisted, with relatively small labor consumption and high production efficiency. But the blade barbed rope is after the second mechanical processing in the artificial processing operations to appear. Therefore, there is a big gap between labor force and production efficiency. These factors lead to the price of the blade barbed rope is more expensive main factors.
- Decorative hook mesh also has flexible characteristics can be used in different fields according to the needs of designers. When using hook mesh in corrosive environment, we must attach great importance to the selection of hook mesh parts materials. Now the hook mesh is often used in breeding fences, captive animals, protective gardens, etc., the wind and sun surrounding environment is difficult to ensure its life, some hook mesh in use for a period of time, due to exposure to the sun and humidity, will appear welding phenomenon, easy to shorten the service life.
There are many kinds of galvanized solution, which can be divided into cyanide plating solution and cyanide plating solution. Cyanide galvanizing solution has good dispersion and covering ability, coating crystallization is smooth and fine, simple operation, wide application range, has been used in production for a long time. However, because the plating solution contains highly toxic cyanide, the gas escaping in the plating process is harmful to the health of workers, and the waste water must be treated strictly before discharge.
Post time: 12-04-23- The most obvious gap in a short period of time is the cross section of this piece, hot dip galvanized wire because it is surface anti-corrosion treatment, so in the cross section of this piece will appear rust, and stainless steel wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.
- Common weight length conversion of barbed rope:
Post time: 03-01-23- 1. Weight
Post time: 20-04-23The iron is clean and clean, and then solvent treatment, after drying immersed in zinc liquid, iron and molten zinc reaction to produce an alloyed zinc layer, the process is: degreasing – washing – pickling – assisted plating – drying – hot dip galvanizing – separation – cooling passivation. The thickness of the alloy layer of hot plating wire mainly depends on the chemical composition of the steel silicon content, the size of the steel cross-sectional area, the roughness of the steel surface, the temperature of the zinc pot, the time of dipping zinc, cooling speed, cold rolling deformation, etc.
- The second is price.
Product features: strong structure, flat surface, with good corrosion resistance, oxidation resistance. The material of small hexagonal mesh is the same as that of other hexagonal mesh, which is generally made of low carbon steel wire, stainless steel wire and galvanized steel wire as raw materials by the hexagonal mesh machine.
Hexagonal twist flower network is divided into heavy hexagonal network and small hexagonal network two categories. Both are made of steel wire braided with various materials, the difference is that the former uses thicker steel wire, and the latter uses finer steel wire braided.
- The material of wire mesh can choose galvanized wire, stainless steel wire, copper wire, coated wire, lacquer wire, etc., different materials are used in different fields, such as construction, culture, decoration, etc.
1, the blade barbed rope damage should be timely corrected
Galvanized hexagonal mesh weaving process: double stranded hexagonal mesh, can be divided into three screws and five screws.