Studies have been carried out with both emulsion paints and powder paints, both with clear results on how the use of Lithopone 30% reduces the appearance of algae in the paint once it has been applied (see photos). 

1. 296 to 1.357 g/cm3 is obtained. The reaction solution is subjected to pressure filtration through a plate frame to obtain a cake-like lithopone powder having a water content of not more than 45%. The mixture is calcined in a dry roaster to change the crystal form of the lithopone, and then acid-washed with sulfuric acid at a temperature of 80 °C. Finally, it is washed with water, reinforced with coloring agent, pressure filtration, drying and milling.

The production of ROS was studied on white blood cells as a model to screen the effect on eukaryotic cells after being exposed to samples and solar simulated irradiation (according to the level of penetration under the skin). For that purpose, the leukocytes were separated from anticoagulated fresh blood using the Ficoll-Hypaque reactive in a well-known technique [33]. Then, 50 μL of suspensions of P25TiO₂NPs (0.2 mg/mL and 0.02 mg/mL), vitaminB2@P25TiO₂NPs (0.2 mg/mL and 0.02 mg/mL) and vitamin B2 (0.2 mg/mL and 0.02 mg/mL) were prepared and mixed with 50 μL of white blood cells suspension. A solution of 3% H₂O₂ was used as positive control and PBS as negative control. Then, the samples were irradiated using the LED panel for 3 and 6 h to simulate the light penetration into the skin. Also, a set of samples was kept in the dark as control. Finally, the ROS were detected through the colorimetric assay employing the nitroblue tetrazolium salt (NBT salt) and the absorbance at 650 nm was measured. The experiment was reproduced twice; the standard deviation was calculated and p-value < 0.05 were considered significant.

To be added to food, this additive must achieve 99% purity. However, this leaves room for small amounts of potential contaminants like lead, arsenic, or mercury (1Trusted Source).