Nowadays, the use of nanoparticles in pharmaceutical and cosmetic products has increased. In the last case, nano-sized components are used without proper characterization of their effects, leading to unwanted and dangerous consequences for the users [1,2].

Lithopone B301

This constant high rate of ROS production leads rapidly to extreme macromolecular oxidation, here it is observed in the AOPP and MDA detected after 3 h in samples treated with bare P25TiO₂NPs (Fig. 6, Fig. 7). Macromolecular oxidation includes, among others, both protein and lipid oxidation. The ROS causes protein oxidation by direct reaction or indirect reactions with secondary by-products of oxidative stress. Protein fragmentation or cross-linkages could be produced after the oxidation of amino acid side chains and protein backbones. These and later dityrosine-containing protein products formed during excessive production of oxidants are known as advanced oxidation protein products (AOPP). They absorb at 340 nm and are used to estimate the damage to structural cell amino acids. Lipid oxidation is detected by the conjugation of oxidized polyunsaturated lipids with thiobarbituric acid, forming a molecule that absorbs light at 532 nm. Polyunsaturated lipids are oxidized as a result of a free-radical-mediated chain of reactions. The most exposed targets are usually membrane lipids. The macromolecular damage could represent a deadly danger if it is too extensive, and this might be the case. Moreover, it could be observed that cellular damage continues further and becomes irrevocable after 6 h and MDA could not be detected. This may be due to the fact that the lipids were completely degraded and cells were no longer viable. Lipids from the cell membrane are the most prone to oxidation. In fact, lipid peroxidation biomarkers are used to screen the oxidative body balance [51]. At the same time, AOPP values are up to 30 times higher for bare nanoparticles in comparison to the functionalized ones.

In 2022, a year after the EFSA recommended against the use of E171, the Food Standards Australia New Zealand (FSANZ) conducted its own reassessment of titanium dioxide as a food additive. The agency concluded that titanium dioxide was indeed safe to use as a food additive. The United Kingdom and Canada came to similar conclusions.

lithopone supplier 30% increases extruder performance and reduces processing costs, improves quality and is suitable for masterbatch for injection of Polyolefins, ABS, Polycarbonate, Polypropylene, Polyethylene, Polystyrene, single layer films, multi-layer films and for white, coloured and filled masterbatch. The combination of lithopone supplier 30 with TiO2 results in improved mechanical properties including higher elongation values and better impact resistance. 

When it comes to sourcing titanium dioxide, it is essential to understand the various processes involved in its production. The two primary production methods are the sulfate process and the chloride process. The sulfate process tends to be more cost-effective in certain contexts, but it also generates a substantial amount of waste, putting pressure on manufacturers to invest in waste treatment technologies. On the other hand, the chloride process is known for its superior quality and lower environmental impact, albeit at a higher production cost.