wholesale active nano titanium dioxide

...

Having thus described the origin and uses of the pigment, we now come to the question, what is lithopone? It is, in short, a chemical compound usually consisting of 30.5 per cent zinc sulphide, 1.5 per cent zinc oxide and 68 per cent barium sulphate, but these proportions vary slightly in the different makes. Lithopone of this composition is sold as the highest grade, either as red seal or green seal, as it best suits the idea of the manufacturer. Many manufacturers, especially in Europe, sell and also export other brands under other seals, containing 24, 20, 18 and as little as 12 per cent of zinc sulphide with very small percentages of zinc oxide, the balance being usually barium sulphate, but sometimes certain portions of China clay or gypsum (calcium sulphate) or whiting (calcium carbonate). Such brands are not a chemical compound, but mechanical mixtures of the chemically compounded lithopone and the admixtures referred to.

...

The production of ROS was studied on white blood cells as a model to screen the effect on eukaryotic cells after being exposed to samples and solar simulated irradiation (according to the level of penetration under the skin). For that purpose, the leukocytes were separated from anticoagulated fresh blood using the Ficoll-Hypaque reactive in a well-known technique [33]. Then, 50 μL of suspensions of P25TiO2NPs (0.2 mg/mL and 0.02 mg/mL), vitaminB2@P25TiO2NPs (0.2 mg/mL and 0.02 mg/mL) and vitamin B2 (0.2 mg/mL and 0.02 mg/mL) were prepared and mixed with 50 μL of white blood cells suspension. A solution of 3% H2O2 was used as positive control and PBS as negative control. Then, the samples were irradiated using the LED panel for 3 and 6 h to simulate the light penetration into the skin. Also, a set of samples was kept in the dark as control. Finally, the ROS were detected through the colorimetric assay employing the nitroblue tetrazolium salt (NBT salt) and the absorbance at 650 nm was measured. The experiment was reproduced twice; the standard deviation was calculated and p-value < 0.05 were considered significant.

...