Galvanized hexagonal net features: easy to use; Save transportation costs. It can be reduced to small rolls and wrapped in moisture-proof paper packaging, taking up less space. Coating thickness uniformity, stronger corrosion resistance; Simple construction, no need for special technology; It has strong ability to resist natural damage, corrosion resistance and adverse weather effects; Can withstand a large range of deformation, but still does not collapse. Fixed heat preservation and heat insulation effect.

In order to orchard special electric galvanized shaft wire in alluvial surface to partially remove the surface film layer, surface impurity and other shortcomings can be found and solved according to the basic technology; Excessive foam is caused by soap and soapable surface active substances such as human fat into the tank. A moderate rate of foam production would be fine. The large amount of fine homogeneous particles in the tank can stabilize the foam layer, but the accumulation of too much solid particles will cause explosion.

Packaging: electric welding net general packaging for moisture-proof paper (color is mostly gray white, yellow, plus trademarks, certificates, etc.), some like 0.3-0.6mm domestic sales of small wire diameter electric welding net, because the wire is relatively soft, coupled with small volume, customers often require packing processing, in order to prevent shipment caused by damage. The wire of electric welding mesh has straight, also has a wavy bend (also known as the Dutch net).

The temperature of large roll galvanized wire should be controlled at 30 to 50℃ during electroplating. Because the chloride ions in the bath are very corrosive, quartz glass heaters are generally used. Continuous production does not need heating, but needs cooling. Cooling can be in the groove side row thin wall plastic pipe, through the flow of tap water cooling, can also be used as a titanium pipe temperature control device.

The management system of the rinsing water after the steel wire pickling should be regularly and regularly discharged after the rinsing water, and the rinsing water should be kept clean and low acid value as far as possible. The pH control is more appropriate. The concentration of plating aid should not be too high. Hot plating wire must be added ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled in the range of 50~80g/L. The addition of ammonium chloride or zinc chloride raw materials without the results of laboratory analysis shall be subject to criticism and education, and economic treatment if necessary.

In moist air, a dense basic zinc carbonate film forms on the surface of zinc. Zinc coating belongs to the anodic coating, it is mainly used to prevent the corrosion of steel, its protective performance and the thickness of the coating is very important. The protective and decorative properties of zinc coating can be improved significantly after passivation treatment, dyeing or coating with light protection agent.