While the conclusions of the EU expert panel were considered in this report, Health Canada's Food Directorate conducted its own comprehensive review of the available science. This included evaluating new scientific data that addressed some of the uncertainties identified by the EU expert panel and were not available at the time of their review.    

According to Procurement Resource, the prices of titanium dioxide are expected to showcase mixed sentiments. With trade and supply-chain normalization, the automotive and construction sectors are estimated to improve their global performance, thus affecting the prices positively.

The basic scenario of resistive switching in TiO₂ (Jameson et al., 2007) assumes the formation and electromigration of oxygen vacancies between the electrodes (Baiatu et al., 1990), so that the distribution of concomitant n-type conductivity (Janotti et al., 2010) across the volume can eventually be controlled by an external electric bias, as schematically shown in Figure 1B. Direct observations with transmission electron microscopy (TEM) revealed more complex electroforming processes in TiO₂ thin films. In one of the studies, a continuous Pt filament between the electrodes was observed in a planar Pt/TiO₂/Pt memristor (Jang et al., 2016). As illustrated in Figure 1C, the corresponding switching mechanism was suggested as the formation of a conductive nanofilament with a high concentration of ionized oxygen vacancies and correspondingly reduced Ti³⁺ ions. These ions induce detachment and migration of Pt atoms from the electrode via strong metal–support interactions (Tauster, 1987). Another TEM investigation of a conductive TiO₂ nanofilament revealed it to be a Magnéli phase Ti_nO_2n−1 (Kwon et al., 2010). Supposedly, its formation results from an increase in the concentrations of oxygen vacancies within a local nanoregion above their thermodynamically stable limit. This scenario is schematically shown in Figure 1D. Other hypothesized point defect mechanisms involve a contribution of cation and anion interstitials, although their behavior has been studied more in tantalum oxide (Wedig et al., 2015; Kumar et al., 2016). The plausible origins and mechanisms of memristive switching have been comprehensively reviewed in topical publications devoted to metal oxide memristors (Yang et al., 2008; Waser et al., 2009; Ielmini, 2016) as well as TiO₂ (Jeong et al., 2011; Szot et al., 2011; Acharyya et al., 2014). The resistive switching mechanisms in memristive materials are regularly revisited and updated in the themed review publications (Sun et al., 2019; Wang et al., 2020).

When used as a base or colorant in a product, titanium dioxide becomes handy in formulas meant to offer a lot of brightness and opacity. Titanium dioxide is so pigmented, in fact, that it’s used not only in white and pastel-colored products but also in darker shades, as well.

Natural barite and anthracite containing more than 95% barium sulfate are mixed and fed at a ratio of 3:1 (mass). After being crushed to a diameter of less than 2cm, it enters the reduction furnace. The furnace temperature is controlled to be 1000-1200°C in the front section and 500-500 in the back section. 600°C, the reduction furnace rotates at a speed of 80 seconds per revolution, and the reaction conversion rate is 80% to 90%.