The reaction liquid is filtered through plate and frame pressure to obtain lithopone in the form of a filter cake with a moisture content of no more than 45%. It is then roasted in a drying furnace to change the crystal form of lithopone, and is then pickled with sulfuric acid at a temperature of 80°C. Finally, it is washed with water, reinforced with colorants, filtered, dried and ground into powder.

Unfortunately, we studied that all of the above methods are employed after machining or forming, and they require a long process chain and costly production types of equipment [21–24]. Therefore, we proposed a titanium alloy implant preparation process that integrated with cutting and surface modification. The oxygen-rich atmosphere increases the partial pressure of oxygen in the oxidizing environment, and the heat generated during the cutting process increases the temperature and the rate of the oxidation. It uses the cutting heat and oxygen-rich atmosphere generated during the cutting process to form the oxide film (TiO₂) to improve the corrosion resistance of the titanium alloy. The experimental equipment is shown in Figure 2. Since the cutting temperature is the most important factor in the oxide film formation process, this paper carried out researches based on theoretical analysis and experimental investigation to acquire an ideal temperature range for the cutting process to achieve the oxide layer.