Drobne et al. used the terrestrial arthropod Porcellio scaber as a test organism for determining the cytotoxic effect of TiO₂ NPs (anatase). The animals were exposed to TiO₂ NPs of two different sizes (25 nm and 75 nm) in the concentration range 10–1000 μg TiO₂/g dry food for 3 to 14 days. No adverse effects, such as mortality, body weight changes or reduced feeding, were observed. In fact, quite the opposite, an enhanced feeding rate, food absorption efficiency and increase in catalase activity were observed. The intensity of these responses appeared to be time- but not dose-dependent. It should also be noted that the concentrations tested in this study were much higher than the predicted concentration (4.8 μg/g soil) at high emission scenario of nano-sized TiO₂. Using the same test organism another group showed that exposure to TiO₂ NPs induced destabilization of cell membrane in the epithelium of digestive glands isolated from exposed animals. They also showed that this effect can be observed after just 30 minutes of exposure.

Lithopone was discovered in the 1870s by DuPont. It was manufactured by Krebs Pigments and Chemical Company and other companies.^[2] The material came in different seals, which varied in the content of zinc sulfide. Gold seal and Bronze seals contain 40-50% zinc sulfide, offering more hiding power and strength.^[3] Although its popularity peaked around 1920, approximately 223,352 tons were produced in 1990. It is mainly used in paints, putty, and in plastics.^[1]

To ensure the optimal precipitation percentage, it is important to carefully control these factors during the precipitation process. For example, a higher concentration of titanium sulfate will typically result in a higher precipitation percentage, but may also lead to the formation of impurities. On the other hand, a lower pH of the reaction mixture can promote the precipitation of titanium hydroxide, but may also result in a lower precipitation percentage.

Risks

Abstract