Moreover, titanium dioxide is also used in rubber formulations to improve the processing and curing properties of rubber compounds. It acts as a catalyst in the vulcanization process, speeding up the cross-linking of rubber molecules and enhancing the overall performance of the final product. This results in rubber products that are stronger, more flexible, and better suited for a wide range of applications.

No. EFSA’s role was limited to evaluating the risks linked to titanium dioxide as a food additive. This included an assessment of relevant scientific information on TiO₂, its potential toxicity, and estimates of human dietary exposure. Any legislative or regulatory decisions on the authorisations of food additives are the responsibility of the risk managers (i.e. European Commission and Member States).

Edelweiss, 14.5 per cent zinc sulphide, 84 per cent barium sulphate, 1.5 per cent carbonate of lime.

Relative to a lot of other things that people should be concerned about, titanium dioxide in my mind, is really low on the list. I would be more worried about some substitutes that people are using for titanium dioxide that don't have decades of research associated with it, said Westerhoff.

What titanium dioxide is really emblematic of ... is the failure of FDA to look back at these old decisions and ask whether its decisions that were made in this case ... 56 years ago (in the 1966 approval) still hold up, he said.

Titanium dioxide (TiO₂) is considered as an inert and safe material and has been used in many applications for decades. However, with the development of nanotechnologies TiO₂ nanoparticles, with numerous novel and useful properties, are increasingly manufactured and used. Therefore increased human and environmental exposure can be expected, which has put TiO₂ nanoparticles under toxicological scrutiny. Mechanistic toxicological studies show that TiO₂ nanoparticles predominantly cause adverse effects via induction of oxidative stress resulting in cell damage, genotoxicity, inflammation, immune response etc. The extent and type of damage strongly depends on physical and chemical characteristics of TiO₂ nanoparticles, which govern their bioavailability and reactivity. Based on the experimental evidence from animal inhalation studies TiO₂ nanoparticles are classified as “possible carcinogenic to humans” by the International Agency for Research on Cancer and as occupational carcinogen by the National Institute for Occupational Safety and Health. The studies on dermal exposure to TiO₂ nanoparticles, which is in humans substantial through the use of sunscreens, generally indicate negligible transdermal penetration; however data are needed on long-term exposure and potential adverse effects of photo-oxidation products. Although TiO₂ is permitted as an additive (E171) in food and pharmaceutical products we do not have reliable data on its absorption, distribution, excretion and toxicity on oral exposure. TiO₂ may also enter environment, and while it exerts low acute toxicity to aquatic organisms, upon long-term exposure it induces a range of sub-lethal effects.

According to the American Chemistry Council, titanium dioxide (TiO2) is an inorganic substance that's used as a white powder in a variety of industrial and consumer goods, including in sunscreen, cosmetics, toothpaste, paint, plastics, food and more.

Hemolysis was studied on suspensions of P25TiO₂NPs (0.2 mg/mL and 0.02 mg/mL), vitaminB2@P25TiO₂NPs (0.2 mg/mL and 0.02 mg/mL) and vitamin B2 (0.2 mg/mL and 0.02 mg/mL) were prepared and mixed with 500 μL of anticoagulated blood (donated by Laboratorio de Hemoderivados, UNC) in a rate of 1/10. A solution of NaCl 10% was used as the positive control and PBS as the negative control. Then, the samples were irradiated using the LED described above for 3 and 6 h to simulate the light penetration into the skin. Also, a set of samples was kept in the dark as control. Finally, the samples were centrifuged and the absorbance at 540 nm was measured in the supernatants. The experiment was reproduced twice; the standard deviation was calculated and p-value < 0.05 were considered significant.

Rebecca Capua is an assistant conservator in the Paper Conservation Department at the Metropolitan Museum of Art since 2009. She received an MA in art history and an Advanced Certificate in art conservation from the Conservation Center, Institute of Fine Arts, New York University in 2007. Her primary area of research is on the materials of American artists of the late 19th and early 20th century. Address: The Sherman Fairchild Center for the Conservation of Works on Paper, Metropolitan Museum of Art, 1000 Fifth Avenue, New York, NY 10028. Email: rebecca.capua@metmuseum.org.

The properties of lithopone are very suitable for use in the production of coatings. Because the ingredients of lithopone are zinc sulfide and barium sulfate, and the more zinc sulfide content, the stronger its covering power. This indicates a paint product with strong white covering power. It is different from water in that it reacts with acid but does not react with alkali. It has a wide range of uses. Because its structural properties are similar to titanium dioxide and its price is relatively cheap, it can also be used as a substitute for some titanium dioxide. Lithopone can be used for coloring paints, inks, pigments, rubber, paper, leather, enamel, etc.

≤12

China is at the forefront of the titanium dioxide industry, with manufacturers like Lomon producing high-quality products such as R996 grade titanium dioxide for the paint industry. Titanium dioxide is a crucial ingredient in paint production, as it provides opacity, brightness, and UV protection to the finished product.

Lithopone’s historical significance is further accentuated by the advancements and modifications that followed its inception. The 1874 patent by J.B. Orr, for instance, ushered in a new white pigment—Orr’s Zinc White. This innovation was attained by co-precipitating zinc sulfate and barium sulfide, followed by a calcination process. Further refinements marked the subsequent decades, the most notable being the enhancement of lightfastness achieved in the 1920s by introducing small amounts of cobalt salts before calcination.

When we purchase lithopone, we must pay attention to its ratio. This can be seen to some extent from the appearance. Basically, we can see that good  products are very delicate. , and the color is also very uniform, a kind of shiny white, while inferior lithopone has uneven particles and wrong luster.