titanium iv oxide factories

Although barium sulfate is almost completely inert, zinc sulfide degrades upon exposure to UV light, leading to darkening of the pigment. The severity of this UV reaction is dependent on a combination of two factors; how much zinc sulfide makes up the pigments formulation, and its total accumulated UV exposure. Depending on these factors the pigment itself can vary in shade over time, ranging from pure white all the way to grey or even black. To suppress this effect, a dopant may be used, such as a small amount of cobalt salts, which would be added to the formulation. This process creates cobalt-doped zinc sulfide. The cobalt salts help to stabilize zinc sulfide so it will not have as severe a reaction to UV exposure.

...
titanium iv oxide factories2025-08-14 21:35
515

2. The preparation of the lining powder: The above-mentioned final immersion liquid 1000 ml in a 2000 ml beaker, heated to 98 ° C, and then added 4 g of ammonium persulfate with a magnetic stirrer stirring 0. 5h, after the oxidation of the solution, adding polyacrylamide 02%。 The solution, the volume of the solution is 0.02%. After lh filtration, the obtained filtrate is subjected to sulfurization and impurity removal, and zinc powder is substituted to obtain a zinc sulfate ammonia refining complex liquid. 122. 9g of antimony sulfide (without water) and 21. 7g of sodium sulfide (without water) are mixed and dissolved in distilled water to obtain a metathesis reaction solution, and a nonionic surfactant 0P-10 (for nonylphenol and epoxy) is added to the solution. The condensate of acetamidine) 0. 2g, the reaction temperature is 40 ° C, the stirring speed is 15m / s, stir well for 40min, then slowly added to 1000ml zinc sulfate ammonia refining complex, continue to stir for 30min and then add quality The fractionation is 30% 3⁄40 2 of desulfurization bleaching, and after bleaching, the nZnS-BaS0 4 crystal filter cake is separated by filtration.

...
titanium iv oxide factories2025-08-14 20:48
1233