Macromolecular oxidation was detected in proteins by the colorimetric measurement of Advanced Oxidation Protein Products (AOPP) and in lipids by the colorimetric quantification of malondialdehyde (MDA). Standard curves were run with chloramine-T and 1,1,3,3 tetraethoxypropane (TEP) for AOPP and MDA methods, respectively [29], [30], [31]. Values were normalized to initial protein content in samples, measured with Bradford reagent [32]. The standard deviation of at least six measures was calculated and p-value < 0.05 were considered significant.

This constant high rate of ROS production leads rapidly to extreme macromolecular oxidation, here it is observed in the AOPP and MDA detected after 3 h in samples treated with bare P25TiO₂NPs (Fig. 6, Fig. 7). Macromolecular oxidation includes, among others, both protein and lipid oxidation. The ROS causes protein oxidation by direct reaction or indirect reactions with secondary by-products of oxidative stress. Protein fragmentation or cross-linkages could be produced after the oxidation of amino acid side chains and protein backbones. These and later dityrosine-containing protein products formed during excessive production of oxidants are known as advanced oxidation protein products (AOPP). They absorb at 340 nm and are used to estimate the damage to structural cell amino acids. Lipid oxidation is detected by the conjugation of oxidized polyunsaturated lipids with thiobarbituric acid, forming a molecule that absorbs light at 532 nm. Polyunsaturated lipids are oxidized as a result of a free-radical-mediated chain of reactions. The most exposed targets are usually membrane lipids. The macromolecular damage could represent a deadly danger if it is too extensive, and this might be the case. Moreover, it could be observed that cellular damage continues further and becomes irrevocable after 6 h and MDA could not be detected. This may be due to the fact that the lipids were completely degraded and cells were no longer viable. Lipids from the cell membrane are the most prone to oxidation. In fact, lipid peroxidation biomarkers are used to screen the oxidative body balance [51]. At the same time, AOPP values are up to 30 times higher for bare nanoparticles in comparison to the functionalized ones.

There are many uses of titanium dioxide that we don't know about because they were made exempt from being on the package in 1977, said Faber, who added that nothing much has changed since – other than the FDA approving some other uses of the color additive, such as expanding the use of mica-based pearlescent pigments (prepared from titanium dioxide) as color additives in distilled spirits over recent years.

4. Solar Cells The photovoltaic industry is another critical area where anatase TiO2 is making an impact. As a semiconductor, it plays a role in dye-sensitized solar cells (DSSCs), providing a pathway for improving energy conversion efficiency in sustainable energy solutions.