tio2 cosmetics factory

Rutile titanium dioxide R-996, white powder, insoluble in water, non-physiological toxicity, stable chemical properties, surface coated with silicon, aluminum, zirconium and organic treatment has excellent pigment performance, whiteness, brightness, good gloss; Strong hiding power, achromatic power and fluidity Rutile titanium dioxide, white powder, insoluble in water, non-physiological toxicity, stable chemical properties, excellent pigment performance after the surface is coated with silicon, aluminum, zirconium and organically treated, whiteness , Brightness, good gloss, hiding power, achromatic power and fluidity are strong, with excellent weather resistance and anti-powder properties.

...

TiO2 comes in many different forms. However, only a few of these forms are considered food-grade (acceptable to be added to food). Many studies that raised concern about the safety of TiO2, including the concern for genotoxicity, used forms of TiO2 that are not considered acceptable for use in food and have different properties than food-grade TiO2. Other studies did use food-grade TiO2, but took steps to break the material down into smaller particles than what would normally be found in food.

...

Hemolysis was studied on suspensions of P25TiO2NPs (0.2 mg/mL and 0.02 mg/mL), vitaminB2@P25TiO2NPs (0.2 mg/mL and 0.02 mg/mL) and vitamin B2 (0.2 mg/mL and 0.02 mg/mL) were prepared and mixed with 500 μL of anticoagulated blood (donated by Laboratorio de Hemoderivados, UNC) in a rate of 1/10. A solution of NaCl 10% was used as the positive control and PBS as the negative control. Then, the samples were irradiated using the LED described above for 3 and 6 h to simulate the light penetration into the skin. Also, a set of samples was kept in the dark as control. Finally, the samples were centrifuged and the absorbance at 540 nm was measured in the supernatants. The experiment was reproduced twice; the standard deviation was calculated and p-value < 0.05 were considered significant.

...
  • Lithopone, a blend of zinc sulfide and barium sulfate, is prized for its opaque nature and ability to confer high brilliance and stability to colors. It has traditionally been used in a wide array of applications, from paints and plastics to rubber and printing inks. However, with the advent of new environmental regulations and the push for safer, non-toxic materials, there has been a renewed interest in lithopone production techniques that minimize hazardous waste and maximize efficiency.